Processing

The iDR-64 DSP mix engine provides all the processing power for 64 input channels and 32 mix outputs. Not only does iLive present all the gain, EQ, assignment and level control you would normally find on a well equipped analogue console, but it brings on board the many outboard racks you would need if you were to insert full dynamics processing and delay across all 64 channels, patch in dynamics, third octave graphic EQ and delay on each of the 32 mixes, and hook up a rack of effects processors. The space and cost saving together with convenient stock and transport handling benefit is huge. And there are no compromises, no 'small print' - all the processing is available all the time - you can never run out of DSP!

iLive features an innovative ‘Processing-Strip’ interface that retains the familiarity of the traditional analogue console with its one-knob-per-function rotary controls and switches, and a display that gives the operator a quick overview of all settings at a glance. To access the processing for a channel or mix simply press its control strip 'SEL' key. For more detailed and graphical information, the parameter information can be displayed on the Touch-Screen too.

Channel processing is also controllable offline and online using ‘iLive System Manager’ software which can be run on your PC or laptop. Control of iLive is transmitted via TCP/IP over Ethernet - both the surface and the iDR10 Mix-Rack are equipped with Ethernet hubs making it easy to set up a control network - so for example, a technician could access channel mix processing such as graphic EQ and delay to set up the PA system from a laptop, while the FOH engineer concentrates on other tasks.

	Preamp
	The mic/line head amp controls are presented as you would find them on a conventional console. You even get a peak indicator. All the preamp parameters can be remote controlled from the console and stored in the scene memories. If the channel is assigned to a digital input then the gain control provides a +/-24dB trim.
	SEL Key
	Press any processing block 'SEL' key to bring up the associated page on the Touch-Screen. Press and hold to PFL the signal at any point in the signal chain, or hold with the COPY, PASTE or RESET keys to edit parameters.
	Insert
	Insert points can be assigned to any input or mix. There is an insert present indicator and IN switch to toggle the inserted processing in or out.
	High Pass filter
	Switch the filter in and dial the required frequency from 20 to 400Hz to eliminate unwanted low frequency pops and noise.

		Gate
		Every input channel features a noise gate with full parameter control including sidechain. The familiar control layout makes the dynamics very easy to use. The signal level is is played behind the threshold setting to help you quickly find the gating point. You can even listen to the sidechain to check the key filter frequency.
		Parametric Equaliser
		4 band fully parametric EQ with HF and LF bands selectable for shelving or bell response. The uncluttered display quickly shows you the overall picture, with further detail available from the graph and values displayed on the Touch-Screen.
		Compressor
		A compressor is available on every input channel and mix master, presenting its own set of controls with a similar layout to the gate, complete with sidechain filter and a signal level display behind the threshold setting. The Touch-Screen adds a response graph and useful histogram of the gain reduction.
		Limiter De-esser
		The third dynamic processor adds a limiter to each input channel and mix master. The input limiter can be switched to become a de-esser, giving the operator both a compressor and a de-esser on vocal channels. There are no compromises - every dynamics processor is instantly accessible.

More Processing